Standard Wheel Carriage Plate and Buildlog laser

Bearings/Motors/Belts/Gears/Etc.

Standard Wheel Carriage Plate and Buildlog laser

Postby ppeetteerr » Tue Jun 26, 2012 2:11 am

Has anyone worked out how to use the Standard Wheel Carriage Plate in a buildlog laser system? I think I can figure it out but I prefer something that is already troubleshot :D .
ppeetteerr
 
Posts: 3
Joined: Sun May 27, 2012 7:27 pm

Re: Standard Wheel Carriage Plate and Buildlog laser

Postby greenvandan » Tue Jun 26, 2012 9:58 am

Are you wanting to use it for the lens carrier? If so there are plates available on the Makerslide store just for that purpose http://store.makerslide.com/index.php?m ... ucts_id=13 It's just a few dollars more than the standard wheel carriage plate and comes pre-drilled for the lens and also has the threaded inserts already pressed in. The standard plate is a little larger but has holes in the right place for the v-wheels, you would have to open up a large hole for the lens and a few smaller ones to fasten it on. Nothing you couldn't handle with a router and a drill.
greenvandan
 
Posts: 43
Joined: Mon May 28, 2012 1:41 am
Location: Baltimore, MD

Re: Standard Wheel Carriage Plate and Buildlog laser

Postby ppeetteerr » Wed Jun 27, 2012 3:50 am

For some reason I thought store.makerslide and inventables were affiliated with one another and carried the same parts. Thanks for pointing that out. It is definatley worth the money.
ppeetteerr
 
Posts: 3
Joined: Sun May 27, 2012 7:27 pm


Return to Mechatronics

Who is online

Users browsing this forum: No registered users and 1 guest