quadmasta wrote:Got any pictures of the linkage?
Greolt wrote:I have had a Homer Simpson DOH!!! moment.
Set up this red dot system, got it all going and adjusted, used for origin setup, all working great. I was very pleased that it was successfull.
So then I moved to integrate it into the machines on board power supplies. Up until then it had been running with a separate temporary independent power supply.
Hooked it up and.........what's going on........it won't work any more.
Then I remembered what I knew all along but had forgotten. The body of the red dot laser module must be insulated from the machine.
When using the separate power supply, all was OK. But as soon as I tied it into machine electrics.......
Went to all that trouble to make a mount with all necessary adjustments built in. Now I have to figure out a way to insulate it.
Greg
whmeade10 wrote:I would bore the hole your red dot laser fits in just a little bit and use a piece of heat shrink tubing to insulate the red dot laser.
jihgo wrote:Hi Greg
Do you have a CAD drawing of the frame you welded up.
I was thinking of making something similar and it would be a good starting point.
Thanks for any assistance you can give.
JH
Users browsing this forum: No registered users and 42 guests