Page 8 of 37
Re: ORD Bot 3D Printer
Posted:
Sun Feb 12, 2012 3:46 am
by technowizard12
Are you using RAMPS for the control? Do you use the RepRap standard control interface?
My apologies if you answered this already.
Re: ORD Bot 3D Printer
Posted:
Sun Feb 12, 2012 4:25 am
by bdring
I am using the RAMPS shield. I am using Sprinter software. I am pretty new to this so I took a low risk well proven easy to use stack
Sprinter
Printrun (pronterface)
Slic3r
You can see the electronics here.
viewtopic.php?f=16&t=1035&start=30#p8344
Re: ORD Bot 3D Printer
Posted:
Sun Feb 12, 2012 3:19 pm
by JeremyBP
The E driver and motor are not even warm.
In that case, try turning the current up a bit.
Re: ORD Bot 3D Printer
Posted:
Sun Feb 12, 2012 3:38 pm
by Gijs
Hi Barton,
First of all, I'm impressed by the simplicity, but also the beauty of the design. While I was browsing your shop, I found you don't ship overseas. I am based in the Netherlands. Is there still a way to get access to the kits once it is ready?
Thanks,
Gijs
BOM
Posted:
Sun Feb 12, 2012 5:45 pm
by bdring
Here is a first cut at the BOM.
http://www.buildlog.net/cnc_laser/erp/i ... tNo=D30050There are probably a lot of little errors in it that I will sort out soon. I put very rough assembly drawings in, but need to clean them up a lot. PDFs and DXFs of the piece parts will come within the next few days.
International shipping. I think there are flat rate options that will put shipping in the $45 - $65.
Re: ORD Bot 3D Printer
Posted:
Sun Feb 12, 2012 8:46 pm
by Guldberg
Perfect!
Love the shopping list. A lot of the stuff (makerslide, wheels, spacers etc.) where in the kickstarter set as far as I can tell, so building one of these should be a breeze:-)
Help...Name For Next Size?
Posted:
Sun Feb 12, 2012 9:55 pm
by bdring
I am working on the documentation and prototype for the larger size. I like the name 'Quantum" for the little guy. What should I name the next size?
This uses the standard 210 square MK1/MK2 heated platforms used on a lot of Mendels. I need a good size term like Quantum, but larger. There may be larger size yet, so I need room to grow in the name so I don't want a name that implies "biggest" ORD Bot.
Midi?
Midway (get it?)
Grand?
Grande?
Mega?
Jumbo?
Bubba?
Re: ORD Bot 3D Printer
Posted:
Sun Feb 12, 2012 10:05 pm
by soehler
Bart
What about leap
Quantum Leap
Sergio
Re: ORD Bot 3D Printer
Posted:
Sun Feb 12, 2012 10:06 pm
by mxk
Planck? Stretching a bad pun further, the biggest one could be Max...
Re: ORD Bot 3D Printer
Posted:
Sun Feb 12, 2012 10:19 pm
by bdring
gORDo?