Well. It happened.
Black ABS is stupid hard to photograph, and my desk lamp really brings out all the imperfections in the surface. It's a really good motivator for tuning my printer.
- Whistle, 0.1mm layer height.
The whistle. This one was a bit interesting. The G-Code adds a little blob right inside the mouthpiece, and at fine layer heights it seems to mess with the timing of the filament flowing, resulting in that little hole. In person you pretty much can't see the ripples, and it feels dead smooth.
- Link Bracelet, 50% scale, 0.2mm layer height.
The link bracelet at this scale is a really tough print. The one I made at 0.1mm broke because the links were so thin. Still, it looks pretty darn good at 0.2mm.