JeremyBP wrote:In my early prints, there was a slight wobble in the Z-axis. I adjusted the screws, and it pretty much went away. But as I started printing faster, I noticed that it came back, and the faster I printed the worse it was. My heated bed is supported by springs. Snugging them down a bit helped cut the wobble. I may try moving to stiffer springs and see if that helps eliminate it entirely.
JeremyBP wrote:There are four holes in the cornder of the platform. You put a screw through the platform, run it through the spring, through the carriage, and into a nut. You can compress the springs for leveling. They also act as shock absorbers if the nozzle runs into the bed. I definitely recommend something stiff, certainly stiffer than ballpoint pen springs. I'm going to try some new ones, and when I decide which ones to order I'll share the part number.
Users browsing this forum: No registered users and 31 guests