Extruder switched off. MINTEMP triggered !
Error:Printer stopped deu to errors. Fix the error and use M999 to restart!. (Temperature is reset. Set it before restarting)
mxk wrote:Are you using bang-bang heating, or PID temperature control?
ok T:3.0 /3.0 B:5.0 /3.0 @:0
ok T:37.9 /3.0 B:12.3 /3.0 @:0
ok T:38.7 /3.0 B:45.5 /3.0 @:0
ok T:9.7 /3.0 B:45.1 /3.0 @:0
ok T:18.5 /3.0 B:36.7 /3.0 @:0
ok T:3.0 /3.0 B:36.1 /3.0 @:0
ok T:3.0 /3.0 B:3.0 /3.0 @:0
tango282 wrote:Are your ohms correct on the thermistor at room temp? (that is the thermistor is good?)
tango282 wrote:Another thread I read was talking about increasing the delay in measuring to allow the ADC to catch up (http://forums.adafruit.com/viewtopic.php?f=25&t=11597) and switching the reference voltage to 3.3 due to noise (they mention USB) (http://www.ladyada.net/learn/sensors/thermistor.html) I am just spit-balling here, like I said I have no idea what I'm talking about..
Users browsing this forum: No registered users and 28 guests