Page 10 of 13
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 2:52 pm
by dzach
I just printed another version of a Z-stop adjuster. It uses M3 screws and an oversized knob with 20 dents so that each dent changes the z-limit by 0.025mm, a full turn is 0.5mm. Maybe an overkill, but it printed, unattended, in 5' at 150mm/s.
I think red does not go well with the Hadron colors.
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 3:04 pm
by dzach
The Skeinforge config files go into a folder named like the profile name, in a hidden path .skeinforge/profiles/extrusion in the user's home directory, e.g.:
- Code: Select all
Profile path:
.skeinforge/profiles/extrusion/ABS-150/<files>
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 3:45 pm
by flurin
I've generate the ooze-j-test_export.gcode file, however it doesn't seem to me to print at 150 mm/s! Attached you' ll find the file. The code F3600 corresponds to a speed of 60 mm/s.
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 3:56 pm
by dzach
Indeed, it is 60mm/s.
Have a look at the Limit panel. It limits the feed rate. Uncheck it if it is checked.
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 3:59 pm
by flurin
... Activate Limit is unchecked. Look into your gcode-file, it should be F9000 = 150 mm/s
Edit:
The only settings I changed are the Multiply > Center X and Y which I've set to 102.5.
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 4:40 pm
by dzach
Another tricky setting that limits speed is cooling. Make sure it is not activated if not needed.
EDIT:
I'm sorry. I think the files I posted are not exactly the ones I used for the test. I forgot I printed the Z-stop after that.
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 4:48 pm
by flurin
Well sure I can check it but as I said above I used exactly your settings.
Have you F9000 in yout gcode-file?
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 4:55 pm
by dzach
Here is the gcode I used for printing @300mm/s. You might need to change the temperature and the acceleration in the very beginning of the file.
I'll print a test @150mm/s now and post the actual settings in a few minutes.
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 5:05 pm
by dzach
Here it is, together with the new gcode produced:
EDIT:I dont know if the gcode is an indication of the actual speed of the print. I've printed successfully @350mm/s, and the gcode shows F21000 but I saw no real improvement over 300mm/s in the actual duration.
Re: dzach's Hadron build
Posted:
Tue Jul 03, 2012 5:26 pm
by flurin
I'll use the new settings. I quickly compared cool.csv, Activate Cool is now set to false. This was the reason.
Thank You!
I 'll post the test results ASAP.