Re: Bill's 80W Laser Build
Posted: Tue Jun 26, 2012 10:07 pm
I currently use 200 steps/rev motors NEMA 23 with 3.1Nm torque using such 4030 drivers. The motors have 8 wires and I run the motors at 4.2 Amps. They give me huge power and accelerations upto 6000mm/s^2 are no problem at all here.
The driver I use is configured for 1/25 microstepping.
If I could have gone for 400 steps motors I surely would have done it.
The driver I use is configured for 1/25 microstepping.
If I could have gone for 400 steps motors I surely would have done it.