I decided to place my laser PS, on a shelf.
Note that I installed an extra 2020 extrusion om the left to support it.
I had it cut it from 1.5 mm stainless steel, I made the holes using my drill press.
... as the 1.5mm stainless steel was cheap I decided also to make a electronics sled out of it also.
The two pieces came cut to the size and the detail cuts where made with dremel cutting disks(lots of
).
Final cost US$ 25. I think it worth it !
Note: Be aware of the sharp edges and corners, make sure you use a grinder to smooth it.