Hi Guys,
As usual, late to the party again.
Ok so here the info on Viki. Repetier works really well and Marlin seems to be a ok with the X3, RAMPS, etc. On the Sanguino based boards like the X1, Sanguinololu and Gen 7 its a bit of a mess with the latest versions of Marlin. It does work with still with Lincomatic's fork which unfortunately not the latest version. Im getting help from Robert FC(buildrob) to try to figure it out since there has been a lot of changes since Lincomatics working version.
So I have attached a pre-configured Marlin for viki (preconfigured by Wired1 for X3) and a preconfigured lincomatic's version for viki (for X1) . Also attached are the suggested pins to use for the viki.
For other controllers please use the pin chart as guidance, in most cases you can assign a different digital pin than suggested. The Pin chart is still a work in progress as I dont have access to the other boards, if you have one of those boards without any entries I would like to know what you used to get it working.
Also, dont forget to install LiquidTWI2 library to compile the firmware. Required for Marlin only.
https://github.com/lincomatic/LiquidTWI2Again,this is a workaround until the merge is complete and the bugs on Sanguino based boards has been worked out.
Thanks.
Roy