Made my gantry end pieces

General Forum Stuff...Introduce yourself

Made my gantry end pieces

Postby mondo50m » Thu Mar 07, 2013 5:39 pm

Just need a quick answer from someone. I have managed to use my homemade cnc router to cut the gantry end plates and the z lift parts. It was touch and go with the spindle being a small dremel type unit. Now that I have done it, it is quite simple. The question is....I cut the parts out of 2mm aluminum. Is this going to be good enough to use in the build? The parts seem to be quite rigid. Any help is appreciated.

Milt
mondo50m
 
Posts: 53
Joined: Thu Aug 25, 2011 5:46 pm
Location: Leesburg, Florida

Return to General Discussion

Who is online

Users browsing this forum: No registered users and 13 guests

cron