Advanced vector Cut Example using RetinaEngrave USB
Posted: Mon Nov 22, 2010 9:23 am
Here is a sample vector cut out of a piece of paper using the direct print advanced vector cutting from RetinaEngrave USB v3.2 using our low 40w Co2 laser. We put this a blue piece of anodized aluminum in the background to show the holes.
This cut was done at 100% speed at 10% power. This entire cut takes about a minute.
The only preparation was that we changed the outside border of the cut to a different color so that it cut it out last. We then direct printed this from CorelDraw and hit the "Go" button. No other prep was needed.
We'd be interested in comparing with people that run Mach3 and see if you can achieve similar results and how long the prep time takes you so will supply the original file if asked and you can show us you have an actual laser up and running.
This cut was done at 100% speed at 10% power. This entire cut takes about a minute.
The only preparation was that we changed the outside border of the cut to a different color so that it cut it out last. We then direct printed this from CorelDraw and hit the "Go" button. No other prep was needed.
We'd be interested in comparing with people that run Mach3 and see if you can achieve similar results and how long the prep time takes you so will supply the original file if asked and you can show us you have an actual laser up and running.