For all you experts out there. I am having a problem with excessive filament bridging internal spaces on my prints. I am using Repetier Host and Slicr for preparation of my print jobs. So far I have tried altering the extruder temp from 230 degrees to 240 with no change. I have attached a photo of a typical print and the extruder setting I am using.
- Extruder settings in Slicr
Filament is 1.75mm ABS. The finished prints are filed with fine spider web like material. It rubs off fairly easily but surely it should be easy to change the settings to avoid it altogether?
Any wise words would be appreciated.
Regards,
Preso