mattrsch wrote:I have the 400 step motors and they work great with the Light Object DSP
mattrsch wrote:I am using Bart's 4 axis driver board with pololu stepper drivers on 8X microstepping
Actually I don't recommend to use TB6560 3axis or 4axis for the DSP. It's a little complicate to do wiring. Plus, overall performance isn't good as a single axis stepping motor with fine resolution and controlling. This board is not the same as the Bart's 4 axis card where I guess he layout all the pins direct to the connection terminal.
GiriPod wrote:Heads up with regard to the 3-axis for LO.
Marco posted on the LO forum that it's not recommended to use the 3-axis controller with their DSP.
http://www.lightobject.info/viewtopic.php?f=8&t=1294Actually I don't recommend to use TB6560 3axis or 4axis for the DSP. It's a little complicate to do wiring. Plus, overall performance isn't good as a single axis stepping motor with fine resolution and controlling. This board is not the same as the Bart's 4 axis card where I guess he layout all the pins direct to the connection terminal.
He recommends separate steppers motor drivers.
Users browsing this forum: No registered users and 6 guests