Drivers for stepper motor

Questions, Suggestions, Tips, Etc

Drivers for stepper motor

Postby Alpi » Sun Mar 05, 2017 12:16 am

Hello there! I am thinking about purchasing for my laser 2.x the M542T drivers and AWC708C Lite DSP (my motors are Nema17 and bed size 30x60cm). From the rest of the blogs and forum I am sure about the Controller. However I have not seen these drivers mentioned here and to me looks like a nice option. Has anyone tried them before? any advice? Thanks! :D :D
Attachments
$_35.jpg
$_35.jpg (20.81 KiB) Viewed 309 times
Alpi
 
Posts: 2
Joined: Wed Mar 16, 2016 8:19 pm

Re: Drivers for stepper motor

Postby terjeio » Sun Mar 05, 2017 11:08 am

Should be ok, maybe a bit overkill for a laser engraver. I am using DM420A which is rated lower current-wise.
terjeio
 
Posts: 20
Joined: Mon Oct 27, 2014 11:22 am


Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 1 guest

cron