Other Extrusion Sources

Questions, Suggestions, Tips, Etc

Other Extrusion Sources

Postby bdring » Wed Mar 09, 2011 1:45 pm

There are a lot of 20mm based extrusions out there. I researched them all when I started my machine. One of the main criteria I was looking for was a small outside corner radius to register the v rail. I found that Misumi had the best. Here are some others show with the v rail attached. I think the only one that is not acceptable is the Maytec one. The others are marginal, but probably acceptable.

erxtr_compare.JPG
Attachments
extr_compare.pdf
(59.73 KiB) Downloaded 578 times
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 7 guests

cron