by bdring » Wed Mar 09, 2011 1:45 pm
There are a lot of 20mm based extrusions out there. I researched them all when I started my machine. One of the main criteria I was looking for was a small outside corner radius to register the v rail. I found that Misumi had the best. Here are some others show with the v rail attached. I think the only one that is not acceptable is the Maytec one. The others are marginal, but probably acceptable.
- Attachments
-
- extr_compare.pdf
- (59.73 KiB) Downloaded 861 times
Bart
"If you didn't build it, you will never own it."