Spacers for the idlers

Questions, Suggestions, Tips, Etc

Spacers for the idlers

Postby StigOE » Fri Sep 16, 2011 8:50 pm

All,

I've started my build of a 2.x laser, but I've hit a couple of snags. One of them is that I can't find any drawings showing which spacers to use for the idler brackets and Y-axis drive shafts. Am I correct in believing that the 1/4" spacers should be used for the smooth idlers and the 9.5mm spacers should be used between the bearing and pulley for the Y-axis shaft?

Stig
StigOE
 
Posts: 96
Joined: Thu May 12, 2011 9:08 pm
Location: Norway

Return to 2.x Laser Support

Who is online

Users browsing this forum: No registered users and 2 guests