danger laserpower setting in DSP from Lightobject

Discussions and help on this commercial controller.

Moderator: twehr

Re: danger laserpower setting in DSP from Lightobject

Postby twehr » Thu Feb 09, 2012 2:49 pm

trwalters001 wrote:Thanks for the input, Tim.

I seem to remember that I measured 22mA at full power input. I'll double-check.

I've emailed Henry to find out what the recommended max should be.

Thanks!

Tim


Here are the typical specs. Looks like, at 22mA, you are good.

Laser Tube Specs.png
Laser Tube Specs.png (5.68 KiB) Viewed 5507 times
tim
--
"The answer is usually easy and obvious once you know what it is." tw

DIYLaser Blog
SemiHomemadeTools.com
twehr
 
Posts: 439
Joined: Mon May 24, 2010 4:49 pm

Previous

Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 14 guests

cron