Moderator: twehr
I don't really see how this could be backlash, as the top and bottom horizontal lines are lined up while the lines inbetween are not.
Regarding your doubled backlash Gav, isn't it the case that your dial gauge was measuring actual backlash in Y - the graphical measurement between opposing rectangles will be 2x backlash (Y+ + Y-) ?
maralb wrote:also I had problems with backlash
it had been written in this post the guilt the shaft couplers
http://www.lightobject.info/viewtopic.php?f=47&t=737
Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller
Users browsing this forum: No registered users and 8 guests