Can someone try cutting this file for me please

Discussions and help on this commercial controller.

Moderator: twehr

Can someone try cutting this file for me please

Postby Greolt » Wed Jul 18, 2012 2:46 am

Can someone with a AWC608 try cutting this file please. Just in paper will be fine.

It is metric. Approx 40mm square.

I used 50mm/sec at 15% power on my 60w laser. Use whatever seems good to you.

Could I ask, please, to photograph the result and post it.

Thanks very much in advance.

Greolt
Greolt
 
Posts: 127
Joined: Tue Nov 29, 2011 7:22 am

Re: Can someone try cutting this file for me please

Postby mattrsch » Wed Jul 18, 2012 3:40 am

I'd be happy to help, but I don't see a file attached :-)
mattrsch
 
Posts: 98
Joined: Wed Jul 21, 2010 5:09 pm

Re: Can someone try cutting this file for me please

Postby Greolt » Wed Jul 18, 2012 3:55 am

Silly me. :oops:

Forum will not allow DXF, so it is zipped.
Attachments
HexHoles.zip
(44.64 KiB) Downloaded 724 times
Greolt
 
Posts: 127
Joined: Tue Nov 29, 2011 7:22 am

Re: Can someone try cutting this file for me please

Postby mattrsch » Wed Jul 18, 2012 4:43 am

Here you go:
IMG_20120717_233837.jpg
HexHoles1

IMG_20120717_233906.jpg
HexHoles2

I cut it at 40mm/s @ 15% power (wild guess)
Everything went pretty smoothly.
mattrsch
 
Posts: 98
Joined: Wed Jul 21, 2010 5:09 pm

Re: Can someone try cutting this file for me please

Postby Greolt » Wed Jul 18, 2012 10:37 am

Thanks for doing that Mattrsch.

I really appreciate it.

Greolt
Greolt
 
Posts: 127
Joined: Tue Nov 29, 2011 7:22 am


Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 1 guest

cron