Moderator: twehr
gavztheouch wrote:Is there a setting to stop the dsp from using small strokes when engraving a thin section of an image.
gavztheouch wrote:Just like what you decribed, except instead of the full 3" on the thin section maybe just a buffer of 1/2" either side to stop it vibrating back and forward on a small section.
kbob wrote:Change your image file so there's an extra pixel to burn outside the finished piece. Then the DSP will travel all the way over to that extra pixel.
Techgraphix wrote:Why should you want the head to move more than necessary??
1).....
2).....
3).....
Kees
Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller
Users browsing this forum: No registered users and 14 guests