Motor tuning with DSP

Discussions and help on this commercial controller.

Moderator: twehr

Motor tuning with DSP

Postby JValliere » Tue Jun 11, 2013 5:42 pm

I have my laser table assembled and some simple test runs made. I'm having difficulty fine tuning the motors to make them smooth. I built a 1.x machine with DSP control (LaserCad).
Issue #1) When I power the table up, the motors will not find home by themselves...I have to give them a "nudge" then they move on their own.

Issue #2) I've finaly got them slowed down enough so they are not "jerky". However, they are not ideal.

These are the issues when running w/o the laser PS plugged in.

Thanks,
Jim
JValliere
 
Posts: 25
Joined: Thu May 23, 2013 2:18 pm

Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: Majestic-12 [Bot] and 2 guests

cron