Page 1 of 1

DSP Conversion

PostPosted: Thu Nov 05, 2015 6:26 am
by redpiperbob
Hi All
I hope someone out there can help me please.
I am building a laser cutter/engraver based on the Bdring model with maker slides and v slot rollers.
I have had this working with
New DSP CO2 Laser Cutter Engraver Machine LCD Motion Controller System PH3 ... EBIDX%3AIT

I am trying to set up this board but I am not having much luck.
If I switch on the machine the x and the y axis go to the home postion fine.
but if I try to move the zxis with the arrow buttons on the machine or the software I somtimes get a jerk then nothing.or I get no movement at all.
I am trying to setup the parameters but with no luck I came across this page ... controller

but the file that is mentioned there will not load into the progamme.
Can anyone help please.


Re: DSP Conversion

PostPosted: Thu Nov 05, 2015 2:17 pm
by sshwarts
Hi. If you can give a little more information. Currently what are your setup parameters? I'm presuming that you can read them from the PC application and maybe share a screen shot?


Re: DSP Conversion

PostPosted: Fri Nov 06, 2015 7:09 am
by redpiperbob
Hi Scott thanks for repling
Here are a couple of shots of the settings in PHcad
That is the contol parameters

that is the manufactuers parameters
My machine is running on GTĀ£ belts and pullies here is an overall picture of it.
Hope you can help

Re: DSP Conversion

PostPosted: Sat Nov 07, 2015 11:59 am
by redpiperbob
Hi There All
Thanks for the help found out how to do it
thanks RSM5178