Moderator: twehr
LeonS wrote:Bill,
Is there a user manual for the Thunder Laser version of the DSP firmware? Are there advantages in switching to TL firmware?
Thanks in advance,
Leon
bdring wrote:If you have a problem with screws, you could always glue the sub panel to the skin. The control panel would still be removable.
J45on wrote:Tim do you have you air assist and exhaust fan triggered from the DSP ?
my i/o port 4 pins 5v, gnd, a pin for the cover switch and one for air and blower ? this pin has +5v all the time
Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller
Users browsing this forum: No registered users and 13 guests