DSP Settings for Rotational Adapter

Discussions and help on this commercial controller.

Moderator: twehr

DSP Settings for Rotational Adapter

Postby twehr » Fri Aug 12, 2011 7:55 pm

I have been noticing some discussions recently about the differences between the Light Object and Thunder Laser DSPs. In one of the postings, someone mentioned the rotational adapter settings not working in the Light Object version. Thought I would set the record straight.

The rotational adapter settings in the current version of the Light Object software work just fine. The settings are different from what they were when I did my previous review of the adapter, but they are still pretty straight forward. So I wrote a short blog about it and posted an Over-The-Shoulder Video about it here: http://diylaser.blogspot.com/2011/08/setting-dsp-laser-controller-advance.html. Take a look and see what you think.

Hope this clears up any confusion about how to use it.
tim
--
"The answer is usually easy and obvious once you know what it is." tw

DIYLaser Blog
SemiHomemadeTools.com
twehr
 
Posts: 439
Joined: Mon May 24, 2010 4:49 pm

Re: DSP Settings for Rotational Adapter

Postby trwalters001 » Sat Aug 13, 2011 11:57 am

Hi Tim,
Thanks much! That clears up a few things.
Nice blog too! :D
Tim
trwalters001
 
Posts: 173
Joined: Sun Oct 24, 2010 10:08 pm
Location: Atlanta, GA


Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 2 guests

cron