DSP Scan Gap Settings

Discussions and help on this commercial controller.

Moderator: twehr

DSP Scan Gap Settings

Postby twehr » Sat Sep 03, 2011 10:06 pm

There has been a bit of discussion about how to set the scan gap for engraving with the DSP controller. Sometimes it still seems a bit confusing (or even magical). So today, I wrote an article on the more general topic of scan gaps and how they relate to vector and photo engraving. If you are interesting in that topic, just pop on over to http://DIYLaser.MidwestLaserArts.com and have a read. Then come back to read all the other goodies here. :D
tim
--
"The answer is usually easy and obvious once you know what it is." tw

DIYLaser Blog
SemiHomemadeTools.com
twehr
 
Posts: 439
Joined: Mon May 24, 2010 4:49 pm

Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 1 guest

cron