Control Settings - Cut Mode

Discussions and help on this commercial controller.

Moderator: twehr

Control Settings - Cut Mode

Postby twehr » Mon Sep 05, 2011 12:32 am

In PHCad Control Settings, there is a setting called Cut Mode. I did not know what it did, until today.

The default Cut Mode, PanelLocation, causes the job to be output where the Origin is set by the control panel origin button at the laser. Switching this to SoftLocation will automatically move the origin to a position that causes the job to be output at the position it holds in the PHCad software workspace.

I have updated the Wiki for PHCad usage with this information. There is also a longer version at my blog.
tim
--
"The answer is usually easy and obvious once you know what it is." tw

DIYLaser Blog
SemiHomemadeTools.com
twehr
 
Posts: 439
Joined: Mon May 24, 2010 4:49 pm

Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 1 guest

cron