Update Manual

Discussions and help on this commercial controller.

Moderator: twehr

Update Manual

Postby bdring » Sat Sep 24, 2011 8:07 pm

Jason sent me the latest Thunder Laser DSP setup documentation. It explains a few mystery features like the foot switch and an output to control exhaust and/or assist air. I will probably incorporate relay drivers into a new new PCB I am working on for the assist air and exhaust.
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Re: Update Manual

Postby dwessels » Sun Sep 25, 2011 6:10 am

Would you mind sharing it?

Thanks
dwessels
 
Posts: 35
Joined: Sat Aug 27, 2011 5:26 pm

Re: Update Manual

Postby J45on » Sun Sep 25, 2011 8:17 am

I added the file to the wiki
Here is the link download/file.php?mode=view&id=1875
J45on
 
Posts: 258
Joined: Thu Mar 31, 2011 11:30 am
Location: Kent,united kingdom

Re: Update Manual

Postby dwessels » Sun Sep 25, 2011 9:16 am

J45on wrote:I added the file to the wiki
Here is the link download/file.php?mode=view&id=1875


Thanks, but the link doesn't seem to work.
dwessels
 
Posts: 35
Joined: Sat Aug 27, 2011 5:26 pm

Re: Update Manual

Postby bdring » Sun Sep 25, 2011 12:15 pm

Sorry, I had updated the existing link on the Wiki. I should have been more clear on that.

I added (Wiring Manual) to the link text now.

http://www.buildlog.net/wiki/doku.php?i ... umentation.
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Re: Update Manual

Postby dwessels » Sun Sep 25, 2011 6:00 pm

I took a look at the air assist / blower section where they recommend a board with relays.

The one thing that I am wondering is what that is hooked up to on the DSP... I didn't see anything except for the HL and LL output for the laser that change when the laser fires.

What is supposed to trigger this board / relay?
dwessels
 
Posts: 35
Joined: Sat Aug 27, 2011 5:26 pm

Re: Update Manual

Postby J45on » Sun Sep 25, 2011 6:28 pm

I think the terminal marked wind on the diagram below
Image
Connects to terminal 3 on the I/O plug called "blow air" in the manual
Image
Mine is marked in chinese and translates to blow air according to google
Image
J45on
 
Posts: 258
Joined: Thu Mar 31, 2011 11:30 am
Location: Kent,united kingdom

Re: Update Manual

Postby bdring » Sun Sep 25, 2011 6:35 pm

The connection table also has a clue.

blow_out.JPG
blow_out.JPG (6.47 KiB) Viewed 11341 times
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA


Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller

Who is online

Users browsing this forum: No registered users and 1 guest

cron