Zat German wrote:Anyone take a shot at tackling a combo fan housing, extruder riser for J Head+Wades?
Oh, what the hell...
http://www.thingiverse.com/thing:22483NB: I have NOT printed this version yet. I did print an earlier version and realized some things weren't right, this is the correction / upgrade.
I am uncertain about the legs which protrude furthest forward, as they are slotted to grip the carriage. If they don't print right for you, or the alignment is off, they're a module (everything in this is modular), so open the .scad, read the first 50 lines or so and follow the directions.
I put in a method to support (OK, bad pun) a J-head assuming a 20mm diameter would provide clearance, but you will have to dig into the code as above to enable it.
There's also a set of side legs which extend to the right to mate up to the other holes in the carriage, also optional (and not pictured).
Please, someone with a well dialed-in printer have a go at this and let me know how it goes.
Next on the project list is a fan mount for a 40mm fan. I don't think the BudaSchnozzle is going to need it, but the J-heads or others might, and I'll make it modular as well.
WB