IPvFletch wrote:Thanks Bart. If you could document which tools you have in the clean room (or better, which you used) that would be very helpful. Is anyone else planning to do a full assembly/writeup on the kit, or is that on you?
IPvFletch wrote: Is anyone else planning to do a full assembly/writeup on the kit, or is that on you?
bdring wrote:The clean room build of the Quantum is done. The BOM was perfect.
bdring wrote:The motors just arrived. I am picking up all the extrusions on Monday, so the Quantums should start going out on Monday.
bdring wrote:There is no need to build a clean room Hadron as the hardware is identical, I will just build the gantry and Y axis to get a final belt length.
bdring wrote:More parts.
What's up with the two different sized pulleys on the Hadron BOM?
Nut Blocks(B17055)? If so, what are they made out of?
bdring wrote:The nut blocks are 10mm thick delrin. I have used a similar design nut on a project with a lot high duty cycle and it works OK. What is the Mendel part made from?
Users browsing this forum: No registered users and 48 guests