brnrd wrote:I just uploaded a thing to eliminate z wobble due to bent threaded rods. I'm still in the process of building a Hadron so I haven't tested it yet, but I expect it to work.
cozmicray wrote:I don't know how your thing works?
If it had a M8 thread in it (or a M8 nut) then the white plastic may provide a preload
and the thing act as an anit-backlash nut.
It seems your peg in a slot constrains in Y-axis and allows slop in X-axis?
Is that where the slop is in the maker-slide?
Ray
fma wrote:BTW, it could also be possible to capture a M8 nut directly in your design, instead of using the original Hadron part... This should lead to a smaller stuff.
I would also use a little piece of metal rod for the index, and maybe close the long hole, to prevent it from opening...
Anyway, this will save me money: I was about to order ACME screw/Delrin nuts...
Users browsing this forum: No registered users and 33 guests