ORD Bot Hadron 3D printer mechanical platform Kit

Topics Related to the ORD Bot Printer

Re: ORD Bot Hadron 3D printer mechanical platform Kit

Postby automationtech » Tue Mar 19, 2013 2:08 am

k4mg wrote:My experiences with my kit from ATI:

Ordered kit on 2/9, per web page expected delivery is in March. No order acknowledgement from ATI.

Kit arrived on 3/11 right on time. I have the following problems with the kit:

1. missing part #20 16 M5 x 30 BHCS (Emailed ATI, says they will mail replacement, the bolts arrived today.

2. part #6, Makerslide 420mm rail, has a dent in the linear rail in a bad spot (Contacted ATI, they asked me to send a picture of the damage, and I did, but have heard no response. I advised ATI that I have had a total of 6 CNC machines, so I have some experience, and I am sure the dent will affect the quality of the print.) No new rail arrived with the bolts above.

3. the Delran lift blocks that raise and lower the X axis on the gantry have holes too large for the 8mm rod, and they are not threaded so couldn’t lift the rod in any case. (My mistake, the way the lift blocks work is changed, and there are new parts in the kit that are threaded. They new parts are not mentioned in the build instructions that I could find, but they are mentioned in the forum)

4. My four plates are of two different colors, with only the extruder being deeply anodized, the other three are washed out light blue. If you go to my build log here:
You can see the difference in the picture of the completed axis.

I plan to finish my build with the defective rail, document further that it doesn't work satisfactorily, and ask again for a replacement rail.

Barry Rimmer

Hi Barry

It is not a defective rail from the picture. That is what we get form makerslide.

You try first, if you have problem, I will replace it for you and take care of you.

http://www.automationtechnologiesinc.co ... 3d-printer
Posts: 46
Joined: Wed Jul 18, 2012 10:20 pm

Re: ORD Bot Hadron 3D printer mechanical platform Kit

Postby SystemsGuy » Tue Mar 19, 2013 4:15 am

Can you post a picture of the problem makerslide?
Posts: 250
Joined: Sat Dec 29, 2012 7:44 am


Return to ORD Bot

Who is online

Users browsing this forum: No registered users and 5 guests