Anyone have the stl of the B30057 Belt Clamp or one for GT2

Topics Related to the ORD Bot Printer

Anyone have the stl of the B30057 Belt Clamp or one for GT2

Postby bloomingtonmike » Fri Apr 19, 2013 3:50 pm

B30057 Belt Clamp

My MXL belts are slipping and my progware belt clamps are junk. Anyone have an STL of the B30057 Belt Clamp? I saw one MXL clamp but it did not look to be in two pieces. Any advice?

Anyone switch to GT2 belts - is there a belt clamp for those??

Mikie
bloomingtonmike
 
Posts: 113
Joined: Thu Dec 20, 2012 3:04 am

Re: Anyone have the stl of the B30057 Belt Clamp or one for

Postby bdring » Fri Apr 19, 2013 4:06 pm

Try using a little super glue. It does not really grab that much on the delrin, but tends to fill in the gaps that make it loose.

Send a picture of the clamp.
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Re: Anyone have the stl of the B30057 Belt Clamp or one for

Postby bloomingtonmike » Sat Apr 20, 2013 4:20 am

The clamp blocks I have look printed by progware. The belt is one piece - is it made of delrin?

Kind of hard to see to take a picture. They are supposed to be these B30057s
bloomingtonmike
 
Posts: 113
Joined: Thu Dec 20, 2012 3:04 am

Re: Anyone have the stl of the B30057 Belt Clamp or one for

Postby k4mg » Sat Apr 20, 2013 12:47 pm

I had the same belt slipping problem with my ATI belt clamps. I think it was because they were from the previous run, and made for holding two ends, back before the belts were continuous. I cut two one inch pieces of some spare belting I had left over from my ShapeOko build and added them to the clamps, and the slipping was fixed.
k4mg
 
Posts: 33
Joined: Mon Feb 25, 2013 10:18 pm

Re: Anyone have the stl of the B30057 Belt Clamp or one for

Postby bloomingtonmike » Sun Apr 21, 2013 4:25 am

I am doing that kinda with gorilla tape. Would like a better more permanent fix.
bloomingtonmike
 
Posts: 113
Joined: Thu Dec 20, 2012 3:04 am


Return to ORD Bot

Who is online

Users browsing this forum: No registered users and 38 guests

cron