keos wrote:Thank you guys for your help.....
keos wrote:My bed temperature rises to 80-90 C and the slows down and stops, it does not reach the target temp of 110C and starts printing.
keos wrote:Then after the initial few layers the bed turns off and continues printing
keos wrote:
the problem i am encountering now is the heated bed, i have watched several videos stating that in slic3r to put "0" in the temperature tab and "0" for the hotend and to control this through pronterface to avoid miss comunication between slic3r and pronterface, but i am uncertain about this after the cube test i printed....
My bed temperature rises to 80-90 C and the slows down and stops, it does not reach the target temp of 110C and starts printing. Then after the initial few layers the bed turns off and continues printing, but as you can see on the cube the corners start to lift and the whole cube becomes somewhat warped and at instances you end up with cracks in the body, so on my next test i will put the temperature in slic3r so it is the same in pronterface...what i don't get is why the temperature of the bed takes to long to reach its target if it reaches at all...
Keos
keos wrote:Flurin, my layer height is set to .3mm
keos wrote: In Slic3r I currently have the following setting; ( layer height set at .4mm )
keos wrote:... does this have anything to do with the baud rate connection my laptop can only handle 115200 could this be the reason of the bed not heating up to its target of 110c
I am using ABS.
Keos
Users browsing this forum: No registered users and 20 guests