ORD Bot Dual Extruder
Posted: Fri Aug 23, 2013 5:28 am
Just thought I'd share my progress on the dual extruder conversion I'm in the middle of. This is using two SeeMeCNC EZStruders and two E3D hotends. I'm using the standard MakerSlide carriage and an Azteeg X3 to run it all. I will be widening the printer to recover the X axis travel that was lost ... I've got the extrusions but need to get a new handle part made. Hopefully I'll have it going this weekend.
Here are the mounts if you're interested: http://www.thingiverse.com/thing:138425
-Rick
Here are the mounts if you're interested: http://www.thingiverse.com/thing:138425
-Rick