Replicator 2 LCD controller
Posted: Wed Nov 27, 2013 2:14 amI have an extra Replicator2 LCD controller, has anyone tried to connect something like this to the ORDBOT, i am just curious..
Keos
Keos
buildlog.net
Building CNC Machines - Laser/Routers/Etc.
https://www.buildlog.net/forum/
Replicator 2 LCD controller
Page 1 of 1
Posted: Wed Nov 27, 2013 2:14 amRe: Replicator 2 LCD controller
Posted: Wed Nov 27, 2013 3:53 pmHow is it controlled? Is it i2c or spi or something?
Re: Replicator 2 LCD controller
Posted: Wed Nov 27, 2013 4:35 pmi dont know i am just tring to find out if anyone attempted this....
keos
keos
Re: Replicator 2 LCD controller
Posted: Wed Nov 27, 2013 5:10 pmMight be difficult since they're using a closed design.
Re: Replicator 2 LCD controller
Posted: Wed Nov 27, 2013 5:19 pmMy understanding was that the frame was the only part that wasn't open at this point and iirc that only started with the Replicator 2's metal frame, which leads me to believe the electronics is open. Did I miss something?
Re: Replicator 2 LCD controller
Posted: Wed Nov 27, 2013 7:20 pmSo I went searching and found this which has schematics and may be the same as your board.
http://www.thingiverse.com/thing:16067/#files
What controller board and firmware are you using? I expect that will be a siginficant part of making it work, more important than if you are using an OrdBot or RepRap Mendel platform or something similar.
http://www.thingiverse.com/thing:16067/#files
What controller board and firmware are you using? I expect that will be a siginficant part of making it work, more important than if you are using an OrdBot or RepRap Mendel platform or something similar.