Sorry for a dumb question but I am having an issue where my extruder temp is reading about 18C too high (registers correctly at room temp). I am using the thermister that came with the helios heated bed from Panucatt since it has insulated leads. I currently have it set to Type 1 for extruder thermistor type but I suspect that is why I am getting almost a 20C differential when hot. Roy says that it is an Epcos 100k but there looks to be a few different Epcos 100k thermistors. He also says that it should be a type 6 in repetier firmware (user defined thermistor table 1). I think he is inferring that it is an Epcos B57560G1104F. I looked and it seems like it's data table is blank under the user defined thermistor table 1.
Is anyone using this thermistor with their hotend and if so would you mind posting your data table for it.
Here is a picture of the thermistor:
Thanks,
Troy