secretgspot wrote:just buy the kit http://www.automationtechnologiesinc.co ... controller
evil2002usna wrote:BTW dont buy the MBE Extruder from QUBD unless you just want the motor and the fan. Trust me and every other review you have read on the internet. No matter what modification you do to it, it will not be reliable. Spend some money on your extruder, it is the most important part of your printer.
evil2002usna wrote:yeah I agree, buy the full kit. I am not sure that all the plates will work between the openbuilds store and makerslide. They are two different takes on generally the same concept, but the dimension on the holes may be off or the v-wheel profile might not match up with the ones from inventables. Everything will probably end up working ok, but why take the risk? The original kit came with an acrylic piece you attached to the x-axis gantry that had the m8 nut press fitted into it. I didnt see anything in your parts list that would allow you to accomplish raising the z-axis up and down.
Users browsing this forum: No registered users and 28 guests