Re: Ordbot recommissioned
Posted: Sun May 10, 2015 6:37 pm
And when I finally got around to patiently considering all the possibilties I found that the Y-axis motor pulley didn't have a set screw.
Okay, had a spare 18 tooth pulley so used that (for some reason the set screw from the latter wouldn't fit). I'm thinking that if I have to have a mis-match, it's beter to have the lower count pulley on the Y-axis for more torque --- is that reasonable?
Okay, had a spare 18 tooth pulley so used that (for some reason the set screw from the latter wouldn't fit). I'm thinking that if I have to have a mis-match, it's beter to have the lower count pulley on the Y-axis for more torque --- is that reasonable?