How straight are your cuts ?

General discussion of laser machines

Re: How straight are your cuts ?

Postby bdring » Sun Oct 30, 2011 2:57 pm

I think some of us are talking about the focal point and some are not. I was talking about the focal point staying the same, but lasersafe1 is right that it changes the shape of the cut. If the circular beam hits the center, you get an hour glass shaped "kerf" through a thick material. If the beam is off center you still get an hour glass shape, but it is at an angle. This will affect the shape of the kerf, making the cut at an angle. There are lens aberrations etc that affect the focal point but not to the extent shown in the pictures.

it will steer the focal point
might be better said...steer the beam.
Bart
"If you didn't build it, you will never own it."
bdring
Site Admin
 
Posts: 2966
Joined: Sun Nov 22, 2009 7:33 pm
Location: Chicago, IL, USA

Re: How straight are your cuts ?

Postby J45on » Sun Oct 30, 2011 7:04 pm

Cheers guys
I had a fiddle today and got the alignment a little better I think :?
Good enough to make a start on my cryptex project ( basically a combination lock with letters )

Image

The outer rings will have letters on and can be moved to reset the combination

Anyway I have maker slide on the way and I have ordered some different optics in the hope I can make a new carriage to fit

Image
J45on
 
Posts: 258
Joined: Thu Mar 31, 2011 11:30 am
Location: Kent,united kingdom

Previous

Return to General

Who is online

Users browsing this forum: No registered users and 1 guest

cron