Mach3 Dir Signals
Posted: Wed May 11, 2011 8:02 pm
Hi All,
Does anyone know what state the direction signal outputs are in when Mach3 is started?
Can they be initialized to a known state?
If I use one of those signals to control the laser, I want to be able to have the laser off at startup!
Thanks!
Tim
Does anyone know what state the direction signal outputs are in when Mach3 is started?
Can they be initialized to a known state?
If I use one of those signals to control the laser, I want to be able to have the laser off at startup!
Thanks!
Tim