Laser PSU Recomendations/Experinences

Electronics related to CNC

Laser PSU Recomendations/Experinences

Postby Techrat » Wed Jul 24, 2013 2:52 am

I am looking to replace the flakey Laser PSU in my K40 machine.

I am slowly exercising all of the demons from this cheap but useless (as purchased) machine. The lates of which is that the laser PSU seems to crap out after just a few minutes of use. I have already replaced the Moshiboard with the LAOS board and am very happy with that so far. Looking to get a power supply that I am equally happy with.

Have been looking at the LightObject 40W PWM power supply and have not found a better alternative but would like feedback from anyone with experience on this particular supply before sinking another $200+ into this machine.

I look forward to hearing from anyone with experience with the Light Object 40W PWM supply.

Thanks,
Jeff
Techrat
 
Posts: 1
Joined: Sun Apr 07, 2013 5:49 pm

Re: Laser PSU Recomendations/Experinences

Postby JValliere » Thu Jul 25, 2013 5:49 pm

I have that PSU in my build. Works flawlessly.
JValliere
 
Posts: 25
Joined: Thu May 23, 2013 2:18 pm

Re: Laser PSU Recomendations/Experinences

Postby kbob » Fri Jul 26, 2013 7:27 am

K40. The stone soup of laser cutters. (-:
Bob
"If you didn't code it, it will never own you." (-:
kbob
 
Posts: 151
Joined: Mon Jul 09, 2012 6:39 am
Location: Eugene, OR, US


Return to Electronics

Who is online

Users browsing this forum: No registered users and 11 guests

cron