Page 1 of 1

PPI in cheap glass CO2 laser tube

PostPosted: Mon Nov 26, 2018 9:43 am
by erikcrane
Hi,

1 year ago I bought a K40 chinese laser machine. The only update I made is air assist head and now I would to upgrade all machine. After I modify working area to use all posible working area, like Ariel Yahani made with his machine [ulr]https://openbuilds.com/builds/uk40ob.3988/[/url], I would upgrade my moshidraw controller.

Searching information about controllers I found the ppi. I have been reading posts in this forum about it and read the entry blog of dirktheeng. Por lo que he leido usar el laser en modo ppi hace que tengas una mejor calidad de corte, el tubo laser se calienta menos y le sacas el maximo partido a la potencia del laser.

After reading about advantage of using PPI I don't understand why is not widely used in DIY machines. Is it because there aren't a plug and play solution? Or is it because only expensive laser tube can use this method of cutting?

Re: PPI in cheap glass CO2 laser tube

PostPosted: Tue Nov 27, 2018 10:19 pm
by Techgraphix
PPI is not a matter of using an expensive laser tube.. every lasertube could do that..
But it's a software thing.. If your software supports that, it will work.
Kees