Moderator: twehr
bluewave65 wrote:Hello to everyone,
i got a problem with PPI setting.
My co2 powersupply simply dryout during cutting.
If i cut a square every line from start is thinner and thinner. ( Power reduction )
Got anybody same problems ?
Maybe quick capacitor discharge ?
I don`t understant it ...
bluewave65 wrote:Coolant is ok
Can i ask you twehr where you get your PS ?
I presume you don`t have any problem with ppi, right ?
Return to Commercial DSP CO2 Laser Engraving/ Cutter Controller
Users browsing this forum: No registered users and 19 guests