Not yet- i'm still testing the hotbeds. I didn't receive all the parts yet, so this weekend i'll only get to assemble (today) / test (tomorrow) the power supplies and motor drivers. Hopefully Monday or Tuesday I'll receive the missing bits to complete assembly. I'm also finalizing the assembly of my beautiful new Hadron and sorting out the extruder and calibration this weekend so that's about all the time i'll have anyways, quite a lot to do alreadybdring wrote:Is it built yet?
Nope. not sure what feature makes you think so - maybe some of the optional through-hole parts (connectors).Does the board have components on both sides. The silkscreen suggests that.
Actually the silkscreen and solder mask are top notch, if they look fuzzy its just the picture - taken from my new android phone. i used to have a proper digital camera but it crapped out on me some time ago.From the picture the quality of the silkscreen and solder mask look very poor. Is it just the picture?
frob wrote:....if they look fuzzy its just the picture - taken from my new android phone. i used to have a proper digital camera but it crapped out on me some time ago.
frob wrote:The only LED on the board is just right of the center screw.
frob wrote:There are 2 faston tabs and a 3-pole screw terminal block (where it says V+ fused heat) with separately fused 10A & 20A terminals for heater power
orcinus wrote:Oh. I *love* blinkenlichts, so that's too bad, but i completely get the reasons. A) no space, B) no pins, C) LCD, right?
Users browsing this forum: No registered users and 2 guests