I have being following this forum for a while now, and my interest in building a laser cutter has increased exponentially. With the limited sale of ShapeOko (I purchased a mechanical kit) and the Inventables introduction of Makerslide, seemed to be a invite to good to be true! However to build your awesome creation I needed a few custom parts, I can source most of the components (extrusion, steppers, belting, fixings and hopefully MakerSlide). Oh I forgot to mention, my biggest hurdle to overcome is the fact I am based in the UK, and I am currently negotiating international shipping. Back to the laser construction, so to make this project successful I will need a few custom parts, including Bearing an motor brackets. So to draw the story to an end, it would be absoloutly GREAT if you could offer this small custom parts kit. So if you do go forward, would you please contact me as soon as possible. As I have previously said I am based in the UK, I know when you did previous kits you did not like international shipping, if this again becomes a problem I may be able to have a USA based address you could post to. Again thank you very much for offering this prospect, and I am very much looking forward to be able to create the superb machine.