canadianavenger wrote:OpenRail is inspired by MakerSlide and is claimed to be fully compatible, so it should work as a drop in replacement if desired. The downside is that it is not available today, but the project is fully funded so should be available soon. You can still get on the rewards on kick starter and get early access.
awesomenesser wrote:canadianavenger wrote:OpenRail is inspired by MakerSlide and is claimed to be fully compatible, so it should work as a drop in replacement if desired. The downside is that it is not available today, but the project is fully funded so should be available soon. You can still get on the rewards on kick starter and get early access.
It is almost fully compatible the only issue is that you will not be able to use the front (side where V rails mount) to mount anything else. For example the motor plates on the Hadron mount to the single open rail in the front of the makerslide. So you would have to redesign a few parts to make it fully compatible.
WhiteB0rd wrote:...
Hmm... think about that.... do the X or Y carriage v-wheels actually go all the way to the end? Nothing says the rails have to run the full length of the extrusion.
WB
Users browsing this forum: No registered users and 45 guests