Gadroc wrote:Yes, once you flush them to the pulley the of the 8" threaded rod will sit flush with the top of the upper bearing plate. Although it was a real pain getting that nylon locking nut threaded on with out marring the upper threads holding onto the rod. I'm sure I'm just missing some trick to do it, but I ended up putting a lock nut on both sides. One ended up turning while the other was where I held on to turn against. Sometimes was difficult to back out the other nut though as well.
Return to Enclosures/Framing Etc.
Users browsing this forum: No registered users and 12 guests