mondo50m wrote:I have that particular laser myself. I have converted mine to an LO DSP.
Milt
mondo50m wrote:Lightobject sells a complete upgrade kit for about $580.00. It is fairly simple to do and should take about 4 hours to complete. I do not remember my settings at all. If it is 3mm acrylic, try using speed of 5 and a power setting of about 9 or 10. These are just estimates, if it does not cut through the 3mm acrylic, then check your beam alignment and the cleanliness of your mirrors and focus lens. These must be clean and the beam must be aligned to work properly. Lightobject.com
Users browsing this forum: No registered users and 7 guests